We get it. The fruity aluminum and glass has a certain appeal. However getting a decent serial connection is a bit of work. Not really hard and a nice way to get started with serial hacking on your Mac!
We assume you’re running a modern version of Mac OS. First we’ll install brew (if you already have it, just skip ahead.
Visit https://brew.sh and use the oneliner you find there to install it. It will take a bit of time but you’ll love it!
Brew is the installer every Mac should ship with. A ton of open source apps will become available to you without the hassle. Just type in
brew install $appname and it will happen!
Install Picocom using
brew install picocom.
Done. It’s that easy.
Plug in a USB-Serial board, and maybe install some drivers to get it working.
On your terminal type
ls /dev/tty.* and hit enter:
If your USB-Serial doesn’t show up in
/dev/tty.*then the driver hasn’t been installed or isn’t working properly (or you have a dead USB port or a dead USB-Serial)
Connect the 3.3v and GND to the header on the back of the badge. Connect the RX of the badge to the TX of the USB-Serial, and the TX of the badge to the RX of the USB-Serial.
Picocom is a bit spartan. Start it using
picocom --imap delbs -b 115200 /dev/tty.SLAB_USBtoUART
/dev/tty.SLAB_USBtoUART you should use the device name you found earlier.
When you see a blank screen, press the Enter key twice. A welcoming prompt should be displayed.
? and get going in the awesome experience. Type in
a and verify the symbols you see match the symbols you see on the badge. If you get question marks in blocks, weird symbols etc, your locale is not set right.
Press control-a and then control-h to see Picocom help
Press control-a and then control-x to exit Picocom